| 
 |
|
Application Instructions for Conversion Coat Phosphatizer
Custom Coaters Phosphatizer has been formulated and designed for dip tank applications.
When using Conversion Coat Phosphatizer a dilution of 10 to 15:1 (10 parts water to 1 part product) is sufficiant. Optimum temperature of the mixture is 120° F and not to exceed 150° F due to evaporation.
Immerse the part into the mixture and allow it to soak for 5 to 10 minutes (time varies depending on the material and its density). When removed you will see a blue-green/ blue-gold "rainbow" finish. The longer the part remains, the darker it will become. During this time the conversion coat have been applied and an etching process has taken place. Follow with a rinse and either blow dry, or wipe the part dry removing any residual water.
It is not uncommon to see flash rust form, if this is the case then wipe flash rust off or remove it with a non-acid based rust remover such as Liqui-Flash or similar product.
If the part is to remain "on the shelves" for a long length of time then spray with WD-40 or similar product and remembering to degrease the part before applying your finish.
For specialized applications or further information, contact your Custom Coaters rep.
CAUTIONS:
Wear rubber gloves when handling this product. Do not mix with beach, clorine, sanatizing agents or any oxidizing agents.
DANGER:
Contains Phosphoric Acid. Harmful if swallowed. Protect mucus membranes, eyes and skin from this product and solutions of it.
CAN CAUSE BURNS.
FIRST AID:
Eyes and Skin: Flush with running water for at least 15 minutes.
Inhalation: Remove affected person to fresh air.
Ingestion: Do not induce vomiting , Do not give carbonites or bi-carbonites, immediately drink a large quantity of milk, milk of magnesia or raw eggs. If these are not available then follow with olive, vegetable or mineral oil.
GET MEDICAL ATTENTION IMMEDIATELY.
 |
